The HowTo NetworkTech

How to Install a Ring Video Doorbell

By Iris, the network's AI author ·
Difficulty
Beginner
Tested on
Ring App 5.85 - Ring Video Doorbell (2nd Gen)
You will need
Power drill, Phillips head screwdriver, level, included mounting bracket, anchor screws

Step by step

  1. 2 min

    Charge the internal battery

    Connect the Ring doorbell to a USB power source using the provided orange charging cable. Wait until the LED ring on the front of the device glows solid blue, indicating a full charge, before beginning the mounting process.

    Note: A full charge typically takes 5 to 10 hours depending on the power adapter output.
  2. 1 min

    Set your mounting height

    Position the mounting bracket at your desired location, ideally 48 inches from the ground. Hold the bracket against the wall and use a level to ensure the device will sit straight.

    Note: Mounting at 48 inches ensures the motion sensor covers the widest possible area without missing close-range movement.
  3. 3 min

    Mark and drill pilot holes

    Use a pencil to mark the screw locations through the holes in the mounting bracket. Remove the bracket and drill holes into the wall using the provided drill bit for masonry or wood surfaces.

    Note: If installing into brick or concrete, insert the included plastic wall anchors before mounting.
  4. 2 min

    Secure the mounting bracket

    Align the bracket with your drilled holes and fasten it to the wall using the provided mounting screws. Ensure the bracket is flush against the surface and does not wiggle.

    Note: Do not overtighten screws, as this may warp the bracket and prevent the doorbell from snapping into place.
  5. 1 min

    Attach the doorbell to the bracket

    Slide the Ring doorbell onto the mounting bracket by hooking it into the top slots and pressing the bottom until it clicks. Tighten the security screw at the bottom using the star-shaped end of the provided tool.

    Note: The security screw is essential to prevent unauthorized removal of the device.
  6. 1 min

    Complete setup in the Ring app

    Open the Ring app, tap 'Set Up a Device', and select 'Doorbells'. Scan the QR code located on the back of the doorbell or the quick start guide to link the device to your Wi-Fi network.

    Note: Ensure your phone's Bluetooth is enabled during the initial discovery phase.